Transfer Belt Error

Upon installation of a new transfer belt an error message asking you to Replace Transfer Belt still shows.

Transfer belt error. The transfer belt is not for your machine. Some of these have a waste toner bottle built into the transfer belt. Verify your account to enable IT peers to see that you are a professional.

Alternating with LEVER UNLOCKING ERROR. I cannot find anything else telling me what to do next. Do not expose the belt to light for any length of time as it is light sensitive.

A transfer belt can be cleaned using a cleaning cycle with a software or through manual cleaning. Gently set the ITB vertically on these sheets of paper as shown below with the handles up. Do NOT handle the transfer belt by the black shiny polymer material.

It is very clean. Open and Close the Front Door. If a second attempt at the reset fails the image transfer belt will need to be replaced.

To fix this problem follow the steps below. 5132018 I think just put the old belt back and restart the printerIf you get the error to replace the belt replace it with the new belt and restart the printersometimes the counters dontt reset and might just reset by re installing the beltHope this will help. Grasp the ITB by the two blue handles at the top.

Power OFF the Machine Wait 60 Seconds and Then Power ON. This will require a service action to the printer. This will clear internal counters which is the only thing I can think of that would bring up an intermittent Transfer Belt Error.