Transfer Case Jack

JK 2007-2018 Jeep - Transfer Case Yoke by.

Transfer case jack. 1 of 2 Go to page. If he can drive it the transfer case is working as any driveshaft failure disables the car. Its just a gear driven offset case with a planetary gearset to split torque front to rear.

Jump to Latest Follow 1 - 20 of 25 Posts. Ive always used one with the big saddle but a lot of jacks seem to have a smaller one these days. It helped me power my stock block Evo to the world record running a 9959 13867.

Floor jacks work fine for axles fuel tanks doors and bumpers but transmissions and transfer cases can be difficult or even dangerous with a floor jack. 14 Items Set Descending Direction. Holes are drilled on the corners of a square with dimensions 45 60 75 plus a central hole of 1-18.

The transfer usually sits right behind the transmission in your drivetrain. 8202015 While the transfer case is still resting on the torsion bar cross member remove the top 3 nuts. If youve got a way to lift the side of the truck up far enough to be able to roll the dropped tranny out then.

Place a floor jack underneath the middle of your transfer case skid. Use a piece of wood to distribute the load on the skid. I slid the transfer case back off the transmission and lowered it out with some wrangling and a friend operating the jack.

Raise the jack up until the t-case is nearly about to touch the bottom of the truck body and secure the jack. Look below for the products available for your custom driveline adjustments. 892009 One thing you can do to be on the safer side is to use a floor jack with a big saddle or if it has a small one use a tough flat block of wood in between to spread the pressure around.