Transfer Case U Joint

1410 Series - 4-316 wide between snap rings.

Transfer case u joint. SLIP YOKES for 4x4 TRUCK TRANSFER CASE. They transfer power from the engine to the wheels and also move the drive shaft up and down in the case of bumps and pits. These transfer cases were used in 1995-2007 GM 12 ton trucks and SUVs as well as 34 ton trucks with the 60 gas engine.

241DHD Transfer Case 1410 U Joint Rear Slip Yoke. We now have round flanges U joint yokes CV Joints and male and female splines to contend with. With 1 Piece Rear Drive Shaft.

Please be aware that most 94-96 trucks with a 241DHD transfer case have a 32 spline output shaft. Figure 6-7 Bolt On Slip On Round Flange Figure 8-9 U-Joint Figure 10 241 Left Hand Drive Right or left hand driveDetermine which side of the vehicle the front output shaft is situated on. 1310 Series - 3-732 wide between snap rings.

Inside Snap Ring Dimension of 2556 IN. U-Joints - Rear transfer case Universal Joint Position - Free Shipping on Orders Over 99 at Summit Racing. These were used in late 1990s and early 2000s model trucks.

Not sure where I shouldve put this thread so I put it here. With 1 Piece Rear Drive Shaft. For use with 1410 Stock Drive Shafts.

NV271 Transfer Case 89595. My noise was just because the drive shafts were getting out of align a little but would go back as you drive making it a come and go noise. 775 inches long 241DHD Rear Output 1410 Series.