Transfer Case Yoke Play

26 spline yokes fit Dana 300 the front of an NP231J some model 20 transfer cases as well as a few other applications.

Transfer case yoke play. 10 spline NP205 transfer case front yoke Major diameter 125 1 34 SEAL SURFACE. One bolt is on the front side near the front driveshaft yoke. The BW4405 transfer case will make noise if theres a difference in tread depth of more than 015mm 006-in between front and rear wheels.

Unbolt the rear drive shaft from the transfer case yoke wrap tape around the U-joint cups and wire the drive shaft up and out of the way of the tail housing. Unscrew the speedometer cable retaining nut then remove the cable from the side of the tail housing. BW4407 TRANSFER CASE FRONT OUTPUT YOKE LARGE CV TYPE FITS FORD F250 F350 96-98 TPD PRO-LINE.

This part replaces part number 53045. 6262010 The following service procedure covers light duty LD heavy duty HD and super heavy duty SHD versions of this transfer case. The reason is that the old yoke is not longer.

NEAPCO N3-3-5431X Transfer Case Slip yoke 1350 Series fits FORD with Borg Warner 1356 1345R Transfer Case with 31 spline rear output CLICK HERE. No growling or clicking so i dont think its that. The prices below assume you will send in you old 10 spline yoke good or bad in to us.

Remove the front output yoke nut holding the yoke with a large pipe wrench or bench vise. Remove the intermediate gear 48 roller bearings three spacer washers and two thrust washers from the case. Transmission with Warn Overdrive option If the Model 18 is equipped with Warn overdrive it must be removed before the transfer case can be removed from the transmission.

1252017 the primary shaft is secured. AVAILABLE 1350 UJ DEEP THROAT COMPARISON. The spacers go between your frame and you transfer case skid plate.